Elektralite Pancake RGBW 108-3W RGBW single source LEDs Instrukcja Użytkownika Pobierz pdf (Strona 4)

5. DMX-512 Control Connection

Connect the provided XLR cable to the female 5-pin XLR output of your Elektralite CP 20 or other DMX

controller. The other end should be connected to the male 5-pin XLR input of the Elektralite LED Pro

Line Pancake. Then daisy-chain out of the first Elektralite LED Pro Line Pancake and into the next

Elektralite LED Pro Line Pancake or other dmx device. Never “Y” split the DMX connection.

If you need more cable, then it should be two core, screened cable fitted with a 5 pin XLR input and

output connector. Please refer to the diagram below.

DMX-512 connection with DMX terminator

For installations where the DMX cable has to run a long distance or is in an electrically “noisy”

environment, it is recommended that a DMX terminator is used. This helps prevent corruption of the

digital control signal. The DMX terminator is simply a 5 pin XLR plug (male) with a 120 Ω resistor

connected between pins 2 and 3. It is then plugged into the output XLR socket of the last Elektralite LED

Pro Line Pancake or other dmx device in the chain. Please see illustration below.

120

DMX line

Address 025 Address 013 Address 001

1 2 3 4 5 6 7 8 9 ... 12 13

Brak uwag

Elektralite Pancake RGBW 108-3W RGBW single source LEDs Instrukcja Użytkownika Strona 4